• Advertisement

Toro PP 20073 w/ Tecumseh stalls under load

Use this forum to discuss small engines, and the equipment or machinery that they power. This is the main section for any technical help posts and related questions.

Re: Toro PP 20073 w/ Tecumseh stalls under load

Postby KE4AVB » Mon Jun 05, 2017 6:39 pm

Thinking about your description of the problem it sounds like a worn cylinder and rings allowing a lot of blow by under load on the 2007 engine.
The truest measure of society is the how it treats its elderly, its pets, and its prisoners.
User avatar
KE4AVB
Forum Pro
 
Posts: 6174
Joined: Mon Nov 04, 2013 11:23 am
Location: TorLand

Re: Toro PP 20073 w/ Tecumseh stalls under load

Postby Luffydog » Mon Jun 05, 2017 9:35 pm

When this unit does this can you safely push the primer bulb and see if the rpms pick back up when you push it.
Luffydog
Forum Pro
 
Posts: 658
Joined: Tue Nov 05, 2013 11:05 am
Location: No telling

Re: Toro PP 20073 w/ Tecumseh stalls under load

Postby jwales » Wed Jun 07, 2017 8:15 am

Well, I think it is time to salvage a couple parts and send the mower to the scrap yard... I checked compression on my older Tecumseh Toro and had 90 +. This one I could get no better than 60, multiple checks. Oh well, the outside appearance does not always relate to the inside.
Thanks for all the advice.
jwales
Guide
 
Posts: 176
Joined: Tue Nov 12, 2013 2:25 pm
Location: Minnesota

Re: Toro PP 20073 w/ Tecumseh stalls under load

Postby lefty » Thu Jun 08, 2017 5:25 am

My first attempted at helping on this forum, so the more experienced members can view this as part suggestion and part inquiry, but could a clogged or partially clogged gas cap vent be contributing to the problem?
lefty
Forum Pro
 
Posts: 1011
Joined: Sun Jun 08, 2014 10:12 am
Location: Massachusetts

Re: Toro PP 20073 w/ Tecumseh stalls under load

Postby jwales » Thu Jun 08, 2017 11:36 am

Lefty, I do not know if that could be a cause but I can tell you it was not the cause here as The fuel tank cap that was on this unit was missing the tin cone underneath so I substituted the one off my personal working mower.
jwales
Guide
 
Posts: 176
Joined: Tue Nov 12, 2013 2:25 pm
Location: Minnesota

Previous

Return to Technical Discussion Forum

Who is online

Users browsing this forum: No registered users and 39 guests