New blade mount design.

[KE4AVB]

I got an large order ready for Rotary so I might one their blades to have a look at it.

Currently they about the same price retail as the MTD/Cub blades. So don't know the customer will go for them but if they do then I can make more profit. But I am thinking I just knock off 20% of the MTD retail price and sell the blades at that price. That way the customer gets a break and I still make a healthy profit margin.

I done got in the 42" 50" and 54" Mtd blade sets for stock but the 46" version is still on BO. No telling when I might sell these blades but the mowers are coming as TSC is selling the crap out of them.

[hanz63]

I'm kinda liking Rotary blades more lately and OEP less.

[KE4AVB]

Well my questions have been answered. They are no where near the same as the high lift blades that I have from CUB/MTD.

OEM LEFT Rotary RIGHT


Longer cutting edge, lower air lift, and narrower width. Now take with a grain of salt as the 42" cut ones are the same design as the Rotary blades.

[hanz63]

So it's kinda like comparing the 942-04290 to the 942-04244? Or even a less pronounced lift? Does the center hole look good from there?

[KE4AVB]

So it's kinda like comparing the 942-04290 to the 942-04244? Or even a less pronounced lift? Does the center hole look good from there?

From what I can by overlaying them they line up well on the long sides of the S.

IF I had an actual spindle would be better but I haven't ordered any yet as I haven't had any need for them yet. Besides I got over $93K in parts now and quickly running out storage space. Darn it I was wanting to decrease my inventory and not increase it.