by KE4AVB » Wed Jun 16, 2021 5:59 pm
That why I asked as I do have PNs for two different pulleys. One is NLA which I have and the other is over $100. Just want verify the size used on Gerry's unit as it has the other PN list in the IPL before I order the king pins.
As for the king pins I was unable break them loose using the bolt method; hence, the heat, a 5/16 pin driver and a three pound sedge. Even with the heat and the hammer they very hard to get out. They had been in there over 40 yrs. They are heavily pitted too. I pretty well destroyed my pin driver.
Why in the Heck don't they use a little anti seize at MTD. I having to design and make a puller for PTO clutches because they won't use the anti seize compound. Unable to find a puller that will work that has a 8-1/2 spread. Everything I tried just slips off due to the radius on the coil's side. I already got the tools for holding the double D spacer (two tools that fit four different double D's) so I can torque the clutches with these and don't have to be a octopus when I do them or find someone to help.
The truest measure of society is the how it treats its elderly, its pets, and its prisoners.