by KE4AVB » Wed Oct 11, 2023 5:51 am
Most 2 cycle Ruixing carbs are Zama clones. And yes it should be the original carb.
Normally Zama carbs and their clones are initially set at 1-1/2 turns from seated on both mixture screws and then you fine low speed first and then the high speed. Just make sure the cutter is not moving when idling. Adjust idle speed as needed.
As top speed I find none listed other than cutter should stroking at 1500-1600 max. I know that doesn't help much. I rather saw an engine RPM spec.
The truest measure of society is the how it treats its elderly, its pets, and its prisoners.