Got it!
Thanks
KE4AVB wrote:Arkie,
That was a couple years ago and would take some digging the actual transaxle but was the common single speed version that is still in use on many of the MTD built mowers. It takes approximately 20 oz. of grease. On the rebuild just make sure some is added to axle areas to prevent premature bushing failure.
I had to rebuild my personal Bolens 700 series last Summer because it developed squeaking noise from axle. When I rebuilt it I found that the one side was never greased from the factory. The 660 series single speed I know is basically the same as the 700 single speed. Pay special attention to the drive shaft and the bevel gears as I have had to replace them because of shifting between forward and reverse and slippage problems on pulls.
You can download 700 series mower service manual from http://www.mymowerparts.com which will have the info servicing the single speed transaxle.
MTD-Service-Repair-Manuals
Return to Technical Discussion Forum
Users browsing this forum: No registered users and 10 guests