model type and code for the crank, rod, piston, and recoil assembly,
130212
3250 01
91101907
model type and code for the block and carb assembly,
135212
c160 01
951129ya
I combined these two engines a few weeks back, The engine originally came off of a generator, and it had a tapered shaft, and I needed a key way, not to mention it burned oil like there was no tomorrow. But my dad and brother were using it yesterday when it started to squeal and then the recoil starter blew up. It was the little ball bearings that came out and scattered all out over the dirt, never to be seen again. I have used that recoil starter on several engines and it died on this one, my question is, how much does this cost to replace, and what can I do to prevent it from happening again?