Greetings All
Installing a new kit into a Walbro WTE-509 carburetor on a Stihl MS260 Chainsaw. I notice the button height on the WTE metering diaphragm is slightly shorter than on a WAT diaphragm and my Walbro "W" gage does not have WTE listed on it. The button on a WAT diaphragm is .060" whereas the button on the WTE diaphragm is only .030. I'm used to only two different button heights, .060" for the recessed lever and .015" (same as the diaphragm gasket thickness) for the flush set lever. My question is; how far below the top of the metering chamber gasket surface is the lever supposed to be set? Any information gladly appreciated. All the best,
Sky