Homelite Trimmer
UT33600A
Carb: WT1059
Dropped off as not running. It would run for about 2-3 seconds after priming and then die. As many times as I liked to try it.
Cleaned the carb and replaced metering diaphragm, which I had an extra of, with the same result. The other diaphragm looks good. Also replaced the screen, which I had lying around. Ran it without the fuel filter and got slightly better results but same effect.
One thing I did notice was a lot of vacuum in the tank. So I assume I have fuel delivery problem. When I removed the primer line, fuel shot out across the room. Rather than buy a kit, I see a new carb is about $30. I'm guessing a new carb will solve the problem but wanted to run it by the crew.