Yeah - It was a typo..KE4AVB wrote:Tnx BGS. Slightly wrong on the number but I found them. They are 926-0341(726-0341).
Not sure how one would fit a 5/8 push nut on a 3/4 shaft , seems it would be a very tough fitI manage to get the 5/8" on but took destroy the first two.
Yeah - Always mystifies me when they do that but then consider the probable volume of the part - costs the same to build 100,000 pieces as 10,000 pieces , pretty much, I thinkOut $15 plus shipping for something that was IPLed wrong. The 5/8" version cost more than double of the 3/4" version.
Yeah seems rather typical - have had feedback from web store customers that called Briggs customer support and they ended up paying twice as much for the same part I *told* them they needed - but their call to briggs, the rep told them it was not the right one and gave them the "correct" part number.. which as it happens, Briggs superseded to the very same one I had on offer.. go figure..Mtd tech support was too stupid to even find them even after an hour on the phone with them. Would be nice if they actually hire people that knew what they were doing. THe first couple I talked to I think couldn't even get out of wet paper bag with both ends open and the third said "All I can go by is what is on the IPL.". Seen I was wasting my time so I just hung up.
Since I manage to get one on I will put a couple sets on next stock order from Tulsa. It took a 1-1/16 box wrench and a two pound hammer so the plastic cap isn't in the best of shape.
bgsengine wrote:Not sure how one would fit a 5/8 push nut on a 3/4 shaft , seems it would be a very tough fit
Return to Technical Discussion Forum
Users browsing this forum: No registered users and 57 guests