So a co-worker brought over his rider (that was a hand me down) to check it out and see if I could get it running. wheeled it into my garage and turn the wheel, click click and wheels wont turn....
After looking under the thing it appears that a gear at the end of the steering column is not fully engaging with the half moon plate with teeth and connected to the tie rods. Has anyone experienced this before? Is it a week point in this machine of was it severly abuse??
I think I can replace these two parts WITHOUT pulling the engine off. I would like to understand how/why this happened instead of just replacing the parts and sending it out the door only to have it come back in a couple years for the same thing.
I have the engine running well and Hydro works well. Have the deck off and thinking about putting a new belt on and sharpening the blades IF I can fix the steering issue.
Any thoughts/experiences would be appreciated.
Joe