I was sure i posted about this but couldn't find it. My friend's 128802 was hard starting and lacked power. I pulled carb and cleaned but in replacing noticed the intake pipe was loose. I tightened it and it ran fine again. Now I have it back just a month or 2 later (not used much either) and it will run only while pumping primer. I pulled carb and it's not a dirty jet so I pulled intake again. It's plastic. There was no gasket and plastic surface was no longer flat. I filed it flat but I have to order gaskets. I plan on using two. The intake shows as 497465 superceding to 794305 kit. I notice the new intake hole is not round but the gasket hole is still round. Old intake has round hole. I guess that there were metal intakes as well as I see note on kit picture about raising coil if going from metal to plastic. Anyone know why hole is non round on the replacement. Port in block is round.
https://www.repairclinic.com/PartDetail ... 05/1567993