Can I get some help on setting the RPM on this. Right now, it's running at about 2700. I think that's too low. I think it should be 3300 or 3600 but I can't figure this chart out.
https://photos.app.goo.gl/XWNLKFfjAE9FPNEv8
It looks like there are two ways I can attack this: Bending the tang on the governor spring OR adjusting the position of the throttle cable where it is anchored to the throttle bracket. The position of the cable doesn't look right to me. If I move it back a little, which will give me more tension on the spring at full throttle, I can increase engine speed without loosing on the bottom. Because it appears that the spring is fully relaxed at about almost 1/2 throttle. And it also looks like there is plenty more room on the top range that's being left on the table. I'd like to try that first unless it's advised against.
Thank you.