Model: 358.350260
Serial: 99257D202257
I got this saw in not running after sitting for a few years. Fuel was bad and lines were junk. The metering diaphragm was very stiff but the carb looks good. I replaced the lines, metering diaphragm, and put her back together. It starts on basically the first or 2nd pull but there's a couple of issues puzzling me.
1. The fuel cap leaks through a little pinhole in the center. Assuming that's a vent but am wondering why fuel is pissing out of it.
2. Not the first time I started it, but like the 3rd time, it screams initially until I kick off the choke. Then it runs pretty well. Never encountered that.
Needs a couple of adjustments, for instance, idle, mixture maybe, although it runs better than most on the first try. The screaming while choked concerns me. By screaming I mean it sounds like it's pinned at full throttle until I kick off the choke.
Thanks