A neighbor dropped off a homelite blower that was working fine until it didn't.
Homelite Model: UT09526
S/N: EU14062D010646
Not getting spark. There doesn't appear to be a kill wire attached to the ignition module on this one. My guess is that when you turn the throttle all the way down, it just chokes fuel off 100% to stop it? The last bit of throttle movement works against some spring pressure. I watched a video on disassembling it and did not see a kill wire going from the ignition coil to ground. And there's no switch on it anywhere or any starting instructions that specify a switch.
This is my first time tackling an ignition problem on this type of maching so this is new to me.
My guess is that if I have no spark, I have a bad ignition module?
Thanks