Oh I got to replace the head after I do a major cleaning.
-
- Advertisement
Just wondering...
3 posts
• Page 1 of 1
Just wondering...
by KE4AVB » Tue Apr 20, 2021 11:31 am
Is this considered a dirty engine and could be the cause of the head failure? I replaced the PTO oil seal about two months ago and now the flywheel side failed and I am fairly certain the engine overheated. It wasn't leaking on the last UV test.
Oh I got to replace the head after I do a major cleaning.
Oh I got to replace the head after I do a major cleaning.
The truest measure of society is the how it treats its elderly, its pets, and its prisoners.
-
KE4AVB - Forum Pro
- Posts: 6174
- Joined: Mon Nov 04, 2013 11:23 am
- Location: TorLand
Advertisement
Re: Just wondering...
by RoyM » Tue Apr 20, 2021 12:40 pm
What are they running it on to get that dirty in such a short time? Methinks that might be a sign of deeper problems.
Briggs and Stratton MST
- RoyM
- Forum Pro
- Posts: 762
- Joined: Tue Nov 05, 2013 2:38 pm
- Location: Okanagan valley British Columbia
Re: Just wondering...
by KE4AVB » Tue Apr 20, 2021 3:08 pm
ZTR.
When went to pull the oil seal after cleaning it nearly fell out. Outside diameter was holding the seal just the inner lip.
When went to pull the oil seal after cleaning it nearly fell out. Outside diameter was holding the seal just the inner lip.
The truest measure of society is the how it treats its elderly, its pets, and its prisoners.
-
KE4AVB - Forum Pro
- Posts: 6174
- Joined: Mon Nov 04, 2013 11:23 am
- Location: TorLand
3 posts
• Page 1 of 1
Return to Technical Discussion Forum
Who is online
Users browsing this forum: No registered users and 25 guests